2-Axis Brushless Gimbal Controller

Kenmerken

Conditie: Nieuw

Type: Quadcopter of Multicopter

Beschrijving

his gimbal controller supported 2-Axis brushless motors and is adjustable, so it can be balanced for camera perfectly.
The original version Brushless Gimbal Controller by Ludwig Färber (Hardware and Software) , Alexander Rehfeldt (Software) and Christian Winkler (Software).
This is an Open Source Project. We add a MOSFET for reverse polarity protection and a status blue LED for status indication.
When you running original firmware (e.g. 049) the LED will show you the startup status.

Hardware Features:
 2-Axis output supported
 ATMega328P microcontroller
 Onboard FT232RL USB-TTL converter
 Input reverse polarity protection
 2~6 cells lipo input
 3 Channels input
 Power and status LED
 Multiport
 UART Port
 MPU6050 6 axis gyro/accel with Motion Processing Unit (IMU board)
 On board logic level converter (IMU board)
 3.3V/500mA LDO voltage regulator (IMU board)
 Dimension: 50mmx50mm
Height: 11mm
 45x45mm mounting holes
 Weight: 27g (include IMU board)

Cable Description: 
German version of the firmware: 
Input: A1 is PITCH (pitch) control, A2 is ROLL (roll)control 
Back screen "PITCH" position represents the pitch axis output, "ROLL" position shows a cross-rolleroutput 
IMU board mounting direction: underside (flat) up, x /-x-axis pointing to the front and rear head direction, y /-y axis pointing to the side of the head 
Russian version of the firmware: 
Input: A0 is PITCH (pitch) control, A1 is ROLL (roll)control 
Back screen "PITCH" position represents the pitch axis output, "ROLL" position shows a cross-rolleroutput 
IMU board mounting direction: IC side up (the planedown), y /-y axis pointing to the front and rear headdirection, x /-x-axis pointing to the side of the head 

Size: 
The main control panel: 50 × 50mm Fixed Pitch: 45mm aperture: 3.1mm 
IMU board: 13 × 26mm

100% Brand New and Full Packing

 ·2-Axis Brushless Gimbal Controller x 1

  ·IMU board x1

  ·1.25-5Pin cable 300mm x1